Structural concrete estimation covers three key quantities: concrete volume (for batching and cost), reinforcing steel bars (RSB/rebar) for strength, and formwork area for temporary supports. Each element โ slab, beam, column, footing โ is computed separately, then consolidated.
Concrete Volume
Concrete is measured in cubic meters (mยณ). Volume formulas by element:
Slab: V = Length ร Width ร Thickness > Beam: V = Width ร Depth ร Length (deduct slab thickness for T-beams) > Column: V = Width ร Depth ร Height (per floor) > Footing: V = Length ร Width ร Thickness + Pedestal volume (if any)
Always measure to the edge of elements and deduct overlapping regions (e.g., where beams frame into columns). Add 5% for wastage in the concrete mix order.
Concrete Mix Design
- 3000 psi (20.7 MPa): 1 part cement : 2 parts sand : 4 parts gravel (1:2:4)
- 3500 psi (24.1 MPa): 1:1.5:3
- 4000 psi (27.6 MPa): 1:1:2 (high-strength columns and footings)
- Cement: ~7.5 bags (40 kg/bag)
- Sand: ~0.5 mยณ
- Gravel: ~1.0 mยณ
RSB Rebar Estimation
Rebar is quantified by weight (kg) or by piece count per diameter. Standard diameters used in Philippine practice: 10mm, 12mm, 16mm, 20mm, 25mm (RSB Grade 40 or Grade 60).
- Count longitudinal bars per element from the structural drawing
- Compute length = element span + hooks (2 ร 12d for standard hooks) + lap splice (40d minimum)
- Multiply by linear density (kg/m): 10mm=0.617, 12mm=0.888, 16mm=1.578, 20mm=2.467, 25mm=3.854 kg/m
- Add stirrup/tie bar quantities: stirrup spacing ร number of stirrups ร perimeter per stirrup
Weight (kg) = Total Length (m) ร Linear Density (kg/m)
Add 10% for wastage and offcuts.
Formwork Area
Formwork is measured in square meters (mยฒ) of contact area:
Slab formwork: Area = Length ร Width (bottom face only) > Beam formwork: Area = (2 ร Depth + Width) ร Length (3 faces) > Column formwork: Area = Perimeter ร Height > Footing: typically no formwork if cast against earth; include if poured in open excavation
Formwork materials in Philippine practice: phenolic board (12mm or 18mm), coco lumber (50ร100mm joists), scaffolding props.
Structural Takeoff Workflow
- Break the structure into elements (per drawing schedule)
- Compute volume, rebar, and formwork per element
- Sum all elements per type
- Apply wastage factors
- Convert to procurement units (bags of cement, lengths of rebar, sheets of plywood)
Using EngEst Pro
EngEst Pro's Structural Calculator handles this takeoff automatically. Add slabs, beams, columns, and footings with their dimensions โ the platform computes concrete volume, Portland cement bags, sand, gravel, RSB rebar per diameter, phenolic board sheets, and coco lumber โ all in one BOQ output ready for bidding.